Table of Contents
Advertisement
Dakota Ultrasonics
transducer and bolt surface. Be sure to always place the transducer in the
same location. This will help to eliminate any potential measurement errors
caused by changing the sound path.
4) Press the ENTER key to automatically adjust the display settings and bring
the waveform into view.
5) Once the signal is displayed, press the MEAS key to return to measurement
mode.
12.10 Unloaded Length and Elongation Measurements
The entire procedure to effectively prepare, setup, and measure is located in the
quick start guide in Chapter Two. Please refer to this section for further instructions.
Find Quality Products Online at:
134
GlobalTestSupply
www.
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
