Table of Contents
Advertisement
Dakota Ultrasonics
B) Battery life indicator – Fully charged batteries will appear filled in solid. Note:
The diagram shows the batteries at approximately 50%.
C) Length Measurement – Digital readout of quantity (English or Metric).
D) Detect Indicator – The broken vertical line displays the zero crossing detection
point on the waveform where the measurement has been obtained. Notice that
the digital quantity readout is the same as the location of the detect indicator
according to the measurements labels F, also in the diagram.
E) Echo Signal – Graphical full waveform representation of the return echo
displayed as an amplitude (vertical or "Y" axis) plotted against time (horizontal or
"X" axis), this time is then converted to a physical measurement in terms of a
specific quantity.
F) Measurement Labels – The measurement labels are calculated and displayed
according to where the left side of the display has been set (Delay), and the
overall viewable area (Width) of the display. Note: The gray hash marks break
the display up into 5 segments, or quadrants.
correspond to the measurement at each hash mark.
G) Units Label - Displays the current quantity.
H) Hot Menus - Each of the fields located under the waveform display are called the
Hot Menu Fields.
adjustments needed to control the display settings, measurement modes, and
group memory control.
activate the tabbed menu items and searching through a variety of menus to
make adjustments.
I) Gate – Used to block signal noise, force detection on a specific waveform or
cycle, and view the threshold according to the waveform and signal amplitude.
There are up to three gates available depending on the measurement mode
selected.
Find Quality Products Online at:
These fields allow quick control of some of the fine
All of these fields can be adjusted without having to
110
GlobalTestSupply
www.
The measurement labels
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
