Setting operation
Touch the numerical part
of the octet to be changed.
Touch
Touch[×]
Touch [YES]
1.
Touch the numerical part of the octet to be changed among the 1st to 4th
octets.
2.
When the ten-key pad appears, enter a numerical value in up to 3 digits,
and touch the
key. If a numerical value outside the setting range is
entered, the following error message appears. Enter a numerical value
again.
For the details of the setting range, refer to the following.
Page 377 Specifications
3.
If necessary, change the setting of [Per. S/W port No.] and [Transparent port
No.].
4.
After the setting change, touch the [×] key.
5.
When the screen shown on the left appears, touch the [YES] key.
23 COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
23.2 GOT IP Address Setting
23
201