24.7
IP Filter Setting
IP filter setting
IP addresses from which access to the GOT is allowed or blocked can be set.
For the details of the IP filter setting, refer to the following.
GT Designer3 (GOT2000) Screen Design Manual
Item
IP filter usage
Transmit/Block
IP address
Range
setting
Target IP address
Exception IP
address
*1 Leave the boxes blank if you do not set any IP addresses.
Display operation of the IP filter setting
GOT setup
Touch
[IP filter setting].
24 DISPLAY AND OPERATION SETTINGS (GOT SET UP)
238
24.7 IP Filter Setting
Description
You can set whether to use or not the IP filter function.
You can set whether to allow or block access from the IP addresses specified in [IP
address setting].
• If [Transmit] is selected
Access from the IP addresses that are set for [Target IP address] is allowed.
Access from the IP addresses that are set for [Exception IP address] is blocked.
• If [Block] is selected
Access from the IP addresses that are set for [Target IP address] is blocked.
Access from the IP addresses that are set for [Exception IP address] is allowed.
You can set whether to register IP addresses by specifying a range.
To specify a range, set the start IP address and the end IP address for [Target IP
address].
You can set IP addresses or IP address ranges to be filtered.
Up to 4 ranges can be set.
This item can be set only when [Range] is selected.
For an IP address range specified in [Target IP address], set IP addresses excluded
from being filtered.
Up to 16 addresses can be set for one range specified in [Target IP address].
IP filter setting
Setting range
Yes/No
<Default: No>
Transmit/Block
<Default: Transmit>
Selected/Not selected
<Default: Not selected>
*1
0.0.0.0 to 255.255.255.255
<Default: Blank>
*1
0.0.0.0 to 255.255.255.255
<Default: Blank>