Installing And Removing The Got; Installing The Got - Mitsubishi Electric GOT SIMPLE Series Operation Manual

7.5

Installing and Removing the GOT

The following shows the procedure for installing and removing the GOT.
For the panel cut dimensions for the GOT, refer to the following.
Page 66 Panel Cut Dimensions

Installing the GOT

The following shows an installation example for the horizontal direction.
For the vertical installation, install the GOT so that the vertical installation arrow printed on the GOT rear face points upward.
Page 51 PART NAMES AND SETTINGS
GS2512-WXTBD
The following shows the procedure for installing the GOT.
1.
Insert the GOT rear face into the panel opening.
GOT
2.
Align the fittings (four fittings) on the installation holes on the GOT, and tighten the screws within the specified torque
range (0.36 N·m to 0.48 N·m).
Tightening the screws with a torque exceeding the specified torque range may deform the GOT front panel.
3.
Remove the protective film from the GOT.
7 INSTALLATION AND REMOVAL
70
7.5 Installing and Removing the GOT
Panel opening