7.9
Installing and Removing the USB cable
The following shows the procedure for installing and removing a USB cable to the USB interface (Host) on the GOT rear face.
For the position of the USB interface (Host), refer to the following.
Page 51 PART NAMES AND SETTINGS
Attach a cable clamp depending on the usage environment, such as when fixing a cable is difficult.
Use a cable clamp RSG-130-V0 manufactured by KITAGAWA INDUSTRIES CO.,LTD. or equivalent.
Installing the USB cable
The following shows the procedure for installing the USB cable.
1.
Install the USB cable to a USB interface (Host) on the GOT rear face.
2.
Insert a cable clamp to the mounting hole for a cable clamp shown in the following figure and push it until you hear a
clicking sound.
For the direction that the band goes through, refer to the arrow in the figure.
3.
Pass the USB cable through a hole of the cable clamp and pull the band to fix the cable.
7 INSTALLATION AND REMOVAL
7.9 Installing and Removing the USB cable
7
81