Table of Contents
Advertisement
Displays and key functions
The following describes the displays for the list monitor.
1)
No.
Item
*1
1)
List display area
2)
Keys
3)
[ ]
*1 The status of contacts and coils is displayed as below.
Type of instruction
LD, AND, OR (Contact instruction (Normal open))
LDI, ANI, ORI (Contact instruction (Normal close))
OUT, SET
RST
MC, STL
LDP, ANDP, ORP, LDF, ANDF, ORF
(Rise or fall contact instruction)
Action for an incorrect key input
If an incorrect key is input, cancel the input contents.
Operations
■Before touching the
GO
Before touching the
key, touch the
■After touching the
GO
Write the command again.
Page 361 Writing commands
Commands finalized by writing and inserting operations are revised (overwritten) with the program writing.
Display contents
The status of contacts and coils is displayed on the left of device displays.
The same operations as in the READ mode of the FX list editor can be executed.
Page 357 Displaying sequence programs
Ends the list monitor.
(When the list monitor is executed on the FX list editor screen, the screen is switched to the FX list editor screen.)
GO
key (before reading/writing the input contents)
CLR
key.
key (after reading/writing the input contents)
3)
2)
Description
Status
■ Displayed
Contact
ON
Contact
OFF
TC: Coil
ON
Except TC: Contact
ON
TC: Reset
ON
Word device
Value: 0
Except TC and word device:
OFF
Contact
Contact
ON
Not monitored
Always ■ not displayed
■ Not displayed
OFF
ON
OFF
OFF
OFF
Value: Except 0
ON
OFF
28 GOT SELF CHECK (DEBUG)
28.2 FX List Editor
28
375
Advertisement
Table of Contents
Troubleshooting
