Changing Operands, Set Values - Mitsubishi Electric GOT SIMPLE Series Operation Manual

Changing operands, set values

Changes the operand section of an applied instruction and OUT (T, C) command set value.
Operation
MODE
Stop the FX PLC
(Read mode)
*1 For decimal numbers, input K, then the number.
For hexadecimal numbers, input H, then the number.
Moving the cursor to the line on which the operand or set value is to be changed
When starting to change an operand or a set value, place the cursor on the line of the operand or set value to
be changed (the line on which the step number is not displayed).
If you place the cursor on the command line, the input operation is not possible.
Example
Changing "MOV D0 D10" to "MOV D0 D123"
Stop the FX PLC
< READ >
MODE
< WRITE >
Move the cursor to the changed
location with or
SP Input the device name and device number
3 MOV
8 LD
SP
Set the
WRITE
3 MOV
mode.
8 LD
12
D 0
D 10
M 10
D 1 2 3 GO
12
D 0
D 123
M 10
28 GOT SELF CHECK (DEBUG)
GO
365
28.2 FX List Editor
28