Starting The Signal Processing Software; Starting The Monitoring & Control Software - Safran CORTEX CRT Quantum User Manual

4.1.1.2. Starting the Signal Processing Software

At the end of the Windows boot-up sequence, the Signal Processing software is automatically started. If the
Demodulator board is present, the following SPS icon (lower right corner) appears:
If the board is not mounted in the chassis or in the case of a major hardware problem, the following message
appears:
and the SPS icon remains yellow:
4.1.1.3. Starting the Monitoring & Control Software
Once the Signal Processing software is running, the Monitoring & Control software is automatically started. If
needed, connect the MCS to the SPS for starting the GUI.
A detailed description of the Graphical User Interface is given in the next sections.
© Safran Data Systems
COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Safran Data Systems
.
Ref. DTU 100042
Is.Rev. 5.17
Date: Dec.
03, 2021Sept. 30, 2021
Page 219