Output Level; Calibration - Safran CORTEX CRT Quantum User Manual

3.8.2.2. Output Level

The output level is programmable.
In case of L/S band operation, the CRT computes automatically:

the output level of the CRT modulator

the gain of the EFC board
to minimize the level of parasites.
In case of bypass mode operation, no gain is applied to the EFC board.

Calibration

3.8.3.
The EFC is calibrated at factory, in order to provide a constant fixed gain independently of the frequency for each
input and a constant fixed level independently of the frequency for each output.
The calibration values are stored in the EFC board memory.
When SPS starts, it gets back these calibration values. This operation could take few seconds. This calibration
phase must be completed before programming and using the EFC.
One status indicates if the calibration is "in progress" or "done".
© Safran Data Systems
COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Safran Data Systems
.
Ref. DTU 100042
Is.Rev. 5.17
Date: Dec.
03, 2021Sept. 30, 2021
Page 214