Table of Contents
Advertisement
3.3.5.2. Outputs
3.3.5.2.1. Post Detection Diversity Combining
In Video Mode: the DCU has two separate outputs. Output # 1 can be routed to a low bandwidth
telemetry unit (TMU) while Output # 2 can feed either a low bandwidth telemetry unit or a high bandwidth
telemetry unit with sub-carrier. Each DCU output can be separately programmed to Channel A or Channel
B or Best Channel or Combined Channels.
In PCM Mode: the DCU offers a single output (Output# 1) connected to a high bandwidth, direct PCM
telemetry unit.
Note: a status in the DCU monitoring table indicates which IF Receiver is Channel A and which one is Channel
B.
Next figure illustrates the signal paths through the combining system:
Polarization 1
IF Demodulation
PM demodulation
Polarization 2
IF Demodulation
Polarization 1
PCM/BPSK,
PCM/QPSK,
PCM/OQPSK
or PCM/PM
Polarization 2
© Safran Data Systems
COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
POST DETECTION DIVERSITY COMBINING IN VIDEO MODE :
Channel A
A
Combiner
Channel B
B
POST DETECTION DIVERSITY COMBINING IN PCM MODE :
Channel A
A
IF Demodulation
Bit Synchronization
BP, DM-M/S decoding
Combiner
Channel B
B
IF Demodulation
Bit Synchronization
BP, DM-M/S decoding
Figure 28 : Post detection Diversity Combining outputs
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Output 1
mA + nB
(m + n = 100%)
Output 2
mA + nB
(m + n = 100%)
Safran Data Systems
.
Ref.
DTU 100042
Is.Rev.
5.17
Date:
Dec.
03, 2021Sept. 30, 2021
To :
Telemetry Units (Low BW only)
Ranging Unit
Video test outputs
To :
Telemetry Units
Video test outputs
To :
Viterbi decoder
Output 1
differential decoder
test points
Frame Synchronizer
Page 55
Advertisement
Table of Contents
