Table 4: I/O Connector Panel - Safran CORTEX CRT Quantum User Manual

C C
ONNECTOR ONNECTOR
T P
YPE ANEL
L
ABEL
BNC Female AGC OUT 3
BNC Female Sts Out/J25
to
Sts Out/J28
BNC Female EXT 1 to EXT 6
Sub-D 25 AZ+
AZ-
EL+
EL-
Note 1: These signals are on a cluster of 6 miniature coacial connectors on the rear panel of the MSP module
Note 2: These signals are on a multiwire ribbon cable connected to the IONUM board located on a panel above the computer I/O connectors. Direct connection to the Samtec
multipin connector is not recommended.
Note 3: These signals are on a cluster of 10 miniature coacial connectors on the rear panel of the MSP module. For Cortex CRT applications, only 5 of the 10 connectors are
used.
Note 4: signal level can be adjusted from registry keys. See section 4.2.8.9.4
© Safran Data Systems
COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
C MSP
ABLE MODULE
S
LEEVE CONNECTOR
L
ABEL LABEL
TEST POINTS (continued)
AGC OUT 3 Note 3
Note 2 I/O NUM board
Not supplied Not supplied
AZ / EL
Not supplied Not supplied

Table 4: I/O Connector Panel

This document is the property of
It cannot be duplicated or distributed without expressed written consent.
SIGNAL
AGC voltage Output 1
Non coherent AGC :
significant from -20 dBm to –60 dBm,
Coherent IF level :
significant from 0 dBm to –100 dBm)
Video Test Points
(see section 2.3.4.1for assignment to internal
signals)
Reserved
Azimuth Error (Antenna Tracking)
Elevation Error (Antenna Tracking)
Safran Data Systems
.
Ref. DTU 100042
Is.Rev.
Date:
30, 2021
E
LECTRICAL CHARACTERISTICS
0 to 10 V, 10 dB/V
2 V = -20 dBm,
+
+10 V = -100 dBm
Requires
high impedance input
LVTTL 50 
N/A
Refer to Cortex DTR User's Manual
Refer to Cortex DTR User's Manual
5.17
Dec. 03, 2021Sept.
Page 5