Operation Manual; Starting And Configuring The Cortex; First Steps; Starting The Pc Workstation - Safran CORTEX CRT Quantum User Manual

4.1. Starting and Configuring the Cortex

First Steps

4.1.1.

4.1.1.1. Starting the PC Workstation

1. Verify that the CORTEX has not been damaged during transportation. If needed, open the top cover and verify
that the electronic sub-assemblies are in good condition.
2. Check that the CORTEX chassis is properly grounded and connected to the AC power via the appropriate
power cord.
3. Switch on the chassis (ON/OFF switch is at the rear panel). Allow 8 to 10 seconds for the power supply to
start.
4. At the front panel display, follow Windows boot-up sequence. The unit is configured to Automatic Login as
Cortex account.
© Safran Data Systems
COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
4. O
PERATION
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Safran Data Systems
.
Ref. DTU 100042
Is.Rev. 5.17
Date: Dec.
03, 2021Sept. 30, 2021
M
ANUAL
Page 218