Safran CORTEX CRT Quantum User Manual page 218

Waveform selection.
In SPS 6.22, a new feature is available.
You can now select the waveform for the sweeping. You now have 2 choices:


You can see on the figure below the waveforms for the following STI100013 values.


Important notes:


© Safran Data Systems
COMMAND RANGING & TELEMETRY UNIT CORTEX
CRT QUANTUM USER'S MANUAL
Triangular (default value)
Sinusoidal.
Sweep Rate = 100Hz
Sweep Range = 1000Hz
Figure 72: Sweeping waveform
If you change the waveform when the sweeping is not in ON mode, it will have no effect.
The STI100013 value will be taken into account but there will be no change on the
sweping.
The waveform change will only be taken into consideration when the sweeping is ON. This
action will restart the sweeping from 0Hz.
The sweep rate corresponds to the slope of the sinus at the start.
This document is the property of
It cannot be duplicated or distributed without expressed written consent.
Safran Data Systems
.
Ref. DTU 100042
Is.Rev. 5.17
Date: Dec.
03, 2021Sept. 30, 2021
Page 138