Commissioning; Function Check; Configuring The Measuring Device; Defining The Tag Name - Endress+Hauser Proline Cubemass C 100 HART Operating Instructions Manual

Proline Cubemass C 100 HART
Parameter
Device tag
Endress+Hauser
10

Commissioning

10.1

Function check

Before commissioning the device, make sure that the post-installation and post-
connection checks have been performed.
• "Post-installation check" checklist →  25
• "Post-connection check" checklist →  33
10.2

Configuring the measuring device

The Setup menu with its submenus contains all the parameters needed for standard
operation.
Structure of the "Setup" menu
Setup
10.2.1

Defining the tag name

To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.
The number of characters displayed depends on the characters used.
For information on the tag name in the "FieldCare" operating tool →  46
Navigation
"Setup" menu → Device tag
Parameter overview with brief description
Description
Enter the name for the measuring point.
10.2.2

Setting the system units

In the System units submenu the units of all the measured values can be set.
→ Select medium
Current output 1
Pulse/frequency/switch output
Output conditioning
Low flow cut off
Partially filled pipe detection
HART input
Advanced setup
User entry
Max. 32 characters, such as
letters, numbers or special
characters (e.g. @, %, /).
Commissioning
→  56
→  57
→  59
→  65
→  68
→  69
→  64
→  70
Factory setting
Promass
53