Data Cloning - Icom IC-P7A Instruction Manual

11
OTHER FUNCTIONS
e Set the desired stand-by condition.
• Select VFO or memory channel.
• Scan or priority watch operation can also be selected.
rWhen the alert is detected, a beep sounds and the follow-
ing indication will be displayed.
WFMAM - DUP
T SQL DTCS
VOL PRIO P SKIP MR
LOW 1 5 9
Show above indications alternately.
t Turn the weather alert function OFF in set mode.
NOTE: While receiving a signal (on a frequency other than
the weather alert ON frequency), the receiving signal or
audio will be interrupted momentarily every 5 sec.
in case the alert function is turned ON. This symptom is
caused by the WX alert function. To cancel these symp-
toms, set the weather alert item OFF in set mode.
Push
61
WFMAM - DUP
ATT T SQL DTCS
VOL PRIO P SKIP
MR
LOW
1 5 9
Push and hold Dual operation

■ Data cloning

Cloning allows you to quickly and easily transfer the pro-
grammed contents from one transceiver to another; or data
from a personal computer to a transceiver using the optional
CS-P7
CLONING SOFTWARE
ATT
D Cloning between transceivers
q Master transceiver:
While pushing and holding [CALL] (
power ON to enter cloning mode.
• The master transceiver is used to send data to the sub-trans-
ceiver.
Sub-transceiver:
While pushing and holding [V/M] (
(approx.)
ON to enter cloning mode.
SCAN
WFMAM - DUP
VOL PRIO P SKIP
LOW 1
"CLONE" and "m" appear
.
MODE
• .
SKIP S
Sub-
Master
transceiver
transceiver
S.MW
WFMAM - DUP
T SQL DTCS ATT
MR VOL PRIO P SKIP
5 9 LOW 1
"CLONE" appears
POWER ON
AT
), turn
•
SCAN
), turn power
MW
T SQL DTCS ATT
MR
5 9