Icom IC-P7A Instruction Manual page 13

D D Starting scan
1. Select VFO mode.
Push [V/M] ( ) to select the VFO mode for full, band
• .
SKIP S MW
and programmed scan operation.
• Select memory mode by pushing [V/M] (
ory or bank scan.
2. Selecting a scanning type
Push and hold [CALL] (
MODE
[DIAL] to select the desired scanning type.
• Available scan types when VFO mode is selected; "ALL" for full
scan; "BAND" for the selected band; one of "PROGxx" (xx=0 to 24)
for programmed scan.
• Available scan types when memory mode is selected; "M ALL" for all
memory scan "B ALL" for all bank scan, "B LINK" for bank link scan,
"BANK" for the selected bank scan.
[DIAL]
[CALL]
• . ) again for mem-
SKIP S MW
) for 1 sec., then rotate
•
SCAN
• Scan type indication examples
• Full scan
• Band scan
• Programmed scan
QUICK REFERENCE GUIDE
3. Starting scan
Push [CALL] ( ) to start the scan.
•
MODE SCAN
• Rotate [DIAL] to change the scanning direction.
• Full/Band scan
WFMAM - DUP DTCS ATT
T SQL
VOL PRIO P SKIP MR
LOW
1 5 9
• All memory/All bank/
Bank link scan
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
4. Cancelling scan
Push [CALL] ( ) again to stop scan.
•
MODE SCAN
✔ For your information
The memory channel number you program the scan edges
into correlate "PROGxx" as follows:
00A/00b: Select "PROG 00" to scan between frequencies
programmed in 00A and 00b channels.
01A/01b: Select "PROG 01" to scan between frequencies
programmed in 01A and 01b channels.
24A/24b: Select "PROG 24" to scan between frequencies
programmed in 24A and 24b channels.
• Programmed scan
WFMAM - DUP DTCS ATT
T SQL
VOL PRIO P SKIP MR
LOW
1 5 9
• Bank scan
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
•
•
•
•
VIII