Cloning; Data Cloning - Icom IC-A110EURO Instruction Manual

D Data cloning
Cloning allows you to quickly and easily
transfer the programmed contents from one transceiver to
another transceiver, or, data from PC to a transceiver using
the optional CS-A110EURO cloning software.
D Transceiver to transceiver cloning
q Connect the OPC-591
CLONING CABLE
the [MIC] jack of the master and slave transceivers.
• The master transceiver is used to send data to the slave trans-
ceiver.
w While pushing and holding [Y] + [Z] + [V/M], push
[POWER] ON to enter cloning mode (master transceiver
only—power ON only for slave transceiver).
• "CLONE" appears and the
transceivers enter the clone
standby condition.
e Push [POWER] on the mas-
ter transceiver.
• "CL-OUT" appears in the
master transceiver's display.
• "CL-IN" appears automati-
cally in the slave trans-
ceiver's display.
e When cloning is finished, turn
power OFF, then ON again to
exit cloning mode.
]
D Cloning using PC
Data can be cloned to and from a PC (IBM compatible) using
the optional CS-A110EURO
OPC-478
sult the CS-A110EURO
details.
D Cloning error
with adapter plugs to
When the display at right ap-
pears, a cloning error has oc-
curred.

CLONING

CLONING SOFTWARE
+ OPC-592
CLONING CABLE
CLONING SOFTWARE
• In this case, both transceivers automatically return to the
clone standby condition and cloning must be repeated.
7
and the optional
. Con-
CLONING CABLE ADAPTER
HELP message for
14