Monitor Function; Attenuator Function - Icom IC-P7A Instruction Manual

4
BASIC OPERATION

■ Monitor function

This function is used to listen to weak signals without disturb-
ing the squelch setting or to open the squelch manually even
when mute functions such as the tone squelch are in use.
➥ Push and hold [SQL] (
frequency.
SCAN
S.MW
SET
SET
The [SQL] (
•
ATT SET
expanded set mode. See page 56 for details.
15
) to monitor the operating
•
ATT SET
WFMAM - DUP T SQL DTCS
VOL PRIO P SKIP MR
LOW 1 5 9
The 1st segment blinks
) key can be set to 'sticky' operation in

■ Attenuator function

The attenuator prevents distortion of a desired signal when
very strong RF signals are near the desired frequency or
when very strong electric fields, such as from a broadcasting
station, are present at your location.
➥ While pushing and holding [FUNC], push [SQL] (
momentarily to toggle the attenuator function ON and OFF.
• "ATT" appears when the attenuator functions is in use.
ATT
SET
Push
ATT
WFMAM - DUP
VOL PRIO P SKIP
LOW 1
SCAN
S.MW
SET
Push and hold Dual operation
• )
ATT SET
Appears
T SQL DTCS ATT
MR
5 9