Icom IC-P7A Instruction Manual page 53

tPush [CALL] (
•
MODE SCAN
and holding [CALL] (
MODE
"S.MW."
yPush and hold [V/M] (
SKIP
condition.
• "SKIP" or "PSKIP" indicator appears, according to the skip se-
lection in step r.
• Skip channel setting
WFMAM - DUP T SQL DTCS ATT
VOL PRIO PSKIP MR
LOW
1 5 9
"SKIP" appears
✔ CONVENIENT!
The skip setting can also be easily set with the following op-
eration.
qSelect the desired memory channel to be set as a skip
channel/frequency.
wWhile pushing and holding [FUNC], push [V/M]
) momentarily to select the skip condition from
( • .
SKIP S MW
"SKIP," "PSKIP" and "OFF (no indication)."
) several times; or while pushing
• ), rotate [DIAL] to select
SCAN
• . ) for 1 sec. to set the skip
S MW
• Program skip setting
WFMAM - DUP T SQL DTCS ATT
VOL PRIO PSKIP MR
LOW
1 5 9
"PSKIP" appears
✔ CONVENIENT!
During VFO scanning, such as programmed scan, the skip
setting can be programmed into the highest blank memory
channel which is automatically selected with the following op-
eration.
q Start the VFO scan.
➥ Select VFO mode with [V/M] (
• Select the desired frequency band with [BAND] (
desired.
➥ Push and hold [CALL] (
scan type selection condition.
➥ Rotate [DIAL] to select the desired scanning type.
• "ALL" for full scan; "BAND" for band scan, "PROGxx" for pro-
grammed scan (xx= 0 to 24; programmed scan edges num-
bers only displayed)
➥ Push [CALL] (
•
MODE SCAN
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
wWhen scan pauses and you want to set the paused fre-
quency as a skip frequency.
➥ Push and hold [FUNC] then push [V/M] (
1 sec. to store the paused frequency into the highest
blank memory channel.
• While pushing and holding [FUNC], scan pauses; and after
writing the frequency, scan resumes.
SCAN OPERATION
• . ).
SKIP S MW
•
TS LOCK
) for 1 sec. to enter
•
MODE SCAN
) again to start the scan.
) for
• .
SKIP S MW
7
), if
7
40