Memory/Bank Scan - Icom IC-P7A Instruction Manual

7
SCAN OPERATION

■ Memory/bank scan

q Select memory mode with [V/M] (
w Set the squelch to the point where noise is just muted.
ePush and hold [CALL] (
scan type selection mode.
r Rotate [DIAL] to select the desired scanning type.
• "M ALL" for all memory scan; "B ALL" for all bank scan; "B LINK"
for bank link scan; "BANK" for bank scan.
SCAN
S.MW
Push
37
• . ).
SKIP S MW
) for 1 sec. to enter
•
MODE SCAN
[DIAL]
SCAN
S.MW
SET
Push and hold Dual operation
• All memory scan selection
WFMAM - DUP ATT
T SQL DTCS
VOL PRIO P SKIP MR
LOW
1 5 9
• Bank link scan selection
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 5 9
1
tPush [CALL] (
•
MODE SCAN
lected scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
y To stop the scan, push [CALL] (
• During all memory/all bank/
bank link scan
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
W LOW FM AM DUP SQL 1 5 T 9 DTCS
IMPORTANT!: To perform memory or bank scan, 2 or
more memory/bank channels MUST be programmed, oth-
erwise the scan never starts.
W FM AM DUP SQL T DTCS
• All bank scan selection
WFMAM - DUP T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW
1 5 9
• Bank scan selection
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
Programmed bank
) momentarily to start the se-
• ).
MODE SCAN
• During bank scan
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
W LOW FM AM DUP SQL 1 5 T 9 DTCS
W FM AM DUP SQL T DTCS