Icom IC-P7A Instruction Manual page 57

D D VFO scan watch
qPush [V/M] (
) to enter memory mode, then rotate
• .
SKIP S MW
[DIAL] to select the memory channel.
wPush and hold [CALL] (
MODE
scan type selection condition to select the scan type, then
push [CALL] (
•
MODE SCAN
scan, if desired.
When scanning memory/bank channels:
Starts memory/bank scan first. Memory/bank scan can-
not be started after VFO scan is started.
eWhile pushing and holding [FUNC], push and hold
[SQL] ( • ) for 1 sec. to enter set mode.
ATT SET
r Rotate [DIAL] to select "PRIO."
tWhile pushing and holding [FUNC], rotate [DIAL] to turn
the priority watch ON.
• Select "BELL" if the priority beep function is necessary.
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
Priority ON
y Push [SQL] (
• ) to exit set mode and start the watch.
ATT SET
• "PRIO" indicator appears.
uPush [CALL] (
) for 1 sec. to enter scan type se-
•
MODE SCAN
lection condition.
iRotate [DIAL] to select the desired scan type from "ALL,"
"BAND" and "PROGxx
(xx= 0–24)
) for 1 sec. to enter
•
SCAN
) again to start memory/bank
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP
MR
LOW 1 5 9
Priority beep ON
."
o Push [CALL] (
•
MODE SCAN
• The transceiver checks the memory channel(s) every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 41)
• During VFO scan watch
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO PSKIP
MR
LOW 1 5 9
Searches VFO frequen-
cies for 5 sec.
• During VFO scan watch with priority beep
WFMAM - DUP T SQL DTCS ATT
VOL PRIO PSKIP MR
LOW 1 5 9
Emits beep and blinks "S" indicator when a signal is re-
ceived on a memory (bank) channel.
!0 W hile pushing and holding [FUNC], push [SQL] (
to cancel the watch and scan.
Push Push and hold
PRIORITY WATCH
) to start the VFO scan watch.
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO PSKIP
MR
LOW 1 5 9
Pauses on a memory (bank)
channel when a signal is received.
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO PSKIP MR
LOW 1 5 9
•
ATT SET
Dual operation
8
8
)
44