Partial Reset; All Reset - Icom IC-P7A Instruction Manual

■ Partial reset

If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing
the memory contents, a partial reset function is available for
the transceiver.
➥ While pushing and holding [FUNC] and [V/M] (
turn the power ON to partially reset the transceiver.
SCAN
S.MW
S.MW
SET
Push Push and hold

■ All reset

POWER ON
AT
The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
• . ), seconds, turn power ON again. If the problem persists, per-
SKIP S MW
form the following procedure.
• Partial resetting is also available. See left for details.
IMPORTANT!:
Resetting the transceiver CLEARS all memory information
and initializes all values in the transceiver, including TV
channel skip setting.
➥ While pushing and holding [FUNC], [V/M] (
[SQL] (
Dual operation
OTHER FUNCTIONS
• ), turn the power ON to reset the CPU.
ATT SET
SCAN
S.MW
S.MW
*The displayed frequency differs
SET
according to tranceiver version.
SET
11
POWER ON
AT
) and
• .
SKIP S MW
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP
MR
LOW 1 5 9
WFMAM - DUP
T SQL DTCS ATT
VOL PRIO P SKIP MR
LOW 1 5 9
11
64