Call Channel Programming; Copying Call Channel Contents - Icom IC-P7A Instruction Manual

6
MEMORY/CALL CHANNELS

■ Call channel programming

q Push [V/M] (
•
SKIP
w Set the desired frequency:
➥ Select the desired band with [BAND] (
➥ Set the desired frequency with [DIAL].
➥ Set other data
audible tone frequency, etc.)
ePush and hold [V/M] (
memory write mode.
• 1 short and 1 long beep sound.
• " " indicator and memory channel number blink.
r Rotate [DIAL] to select the desired call channel.
• " " indicator and call channel number "C0" or "C1" blink.
• While pushing and holding [FUNC], rotate [DIAL] to select mem-
ory channel in 10 channel steps.
t Push and hold [V/M] (
• 3 beeps sound
S.MW
33
) to select VFO mode, if necessary.
.
S MW
•
TS LOCK
(e.g. offset frequency, duplex direction, sub-
, if desired.
) for 1 sec. to enter select
• .
SKIP S MW
• . ) for 1 sec.
SKIP S MW
[DIAL]
SCAN
S.MW
SET

■ Copying call channel contents

qPush [CALL] (
channel.
wRotate [DIAL] to select the desired call channel.
).
ePush and hold [V/M] (
memory write mode.
• 1 short and 1 long beeps sound.
• " " indicator and memory channel number blink.
• Do not hold [V/M] (
call channel contents will be copied to VFO.
rRotate [DIAL] to select the desired target memory chan-
nel.
tPush and hold [V/M] (
contents.
CONVENIENT!:
When you want to copy the call channel contents to the VFO,
push and hold [V/M] (
) momentarily to select a call
•
MODE SCAN
) for 1 sec. to enter select
• .
SKIP S MW
) for more than 2 sec. otherwise the
• .
SKIP S MW
• . ) for 1 sec. to transfer the
SKIP S MW
[DIAL]
SCAN
SCAN
S.MW
S.MW
SET
) for 2 sec. as in steps e.
• .
SKIP S MW