Setting A Frequency; Setting A Tuning Step - Icom IC-P7A Instruction Manual

3
FREQUENCY AND CHANNEL SETTING

■ Setting a frequency

q Push [V/M] (
•
SKIP
w Select the desired frequency band with [BAND] (
• Or, while pushing and holding [BAND] (
to select the desired frequency band.
e Rotate [DIAL] to select the desired frequency.
• The frequency changes according to the preset tuning steps.
See the section at right for setting the tuning step.
• While pushing and holding [FUNC], rotate [DIAL] to change the
frequency in 1 MHz steps (default).
SCAN
S.MW
SET
The 1 MHz tuning step (dial select step) can be set to
100 kHz, 1 MHz or 10 MHz tuning steps in set mode. See
p. 17 for details.
11
) to select VFO mode, if necessary.
.
S MW
• ), rotate [DIAL]
TS LOCK
WFMAM - DUP
T SQL
[DIAL]
VOL PRIO P SKIP
MR
LOW 1 5 9
[DIAL] changes the fre-
quency according to the
selected tuning step.
WFMAM - DUP
T SQL
VOL PRIO P SKIP MR
LOW 1 5 9
While pushing
[DIAL] changes the frequen-
cy in 1 MHz steps (default).

■ Setting a tuning step

The tuning step can be selected for each frequency band.
The following tuning steps are available for the IC-P7A.
• ).
TS LOCK
• 5.0 kHz*
• 12.5 kHz • 15.0 kHz • 20.0 kHz • 25.0 kHz • 30.0 kHz
• 50.0 kHz • 100.0 kHz • 200.0 kHz
* Appears for below the 500 MHz bands only.
Appears for the VHF air band only.
†
‡ Appears for the AM broadcast band only.
D D Tuning step selection
qPush [V/M] (
DTCS ATT
select VFO mode, if neces-
sary.
wPush [BAND] (
several times to select the
desired frequency band.
• Or, while pushing and hold-
ing [BAND] (
DTCS ATT
[DIAL] to select the desired
frequency band.
eWhile pushing and holding
[FUNC],
[FUNC],
( •
TS LOCK
enter tuning step set mode.
rRotate [DIAL] to select the
desired tuning step.
tPush [BAND] (
return to VFO mode.
• 6.25 kHz* • 8.33 kHz † • 9.0 kHz
) to
• .
SKIP S MW
• )
TS LOCK
), rotate
•
TS LOCK
push
[BAND]
) momentarily to
WFMAM - DUP
VOL PRIO P SKIP
LOW
1
) to
•
TS LOCK
5 kHz tuning step
• 10.0 kHz
‡
[DIAL]
SCAN
S.MW
SET
T SQL DTCS ATT
MR
5 9