Left Side Panel; Removing The Left Side Panel - HP Visualize B1000 Supplementary Manual

Parts Removal and Replacement

Left Side Panel

Left Side Panel
This section describes how to remove and replace the Left Side Panel.
NOTE Prior to removing the Left Side Panel, the Terminators and Cables need to be
removed from the back of the workstation. See the appropriate section(s) for
the steps on how to remove this component.
NOTE Only the left side panel is removed. The left side panel is the one on the left
when facing the front of the workstation.

Removing the Left Side Panel

1. Remove the two T-15 Torx thumbscrews located in the top and bottom right edge of the
back side of the workstation, as shown below.
Figure 2-5. Opened Side Panel
Side-Panel Thumbscrew
Safety
Interlock Switch
2. Remove the left side panel by grasping the back edge of the panel and rotating the
panel outward as shown above. Unhinge the panel and pull it away from the
workstation. Set the panel and its screws aside.
14
Hinge Slots
2 Side-Panel Hook
Safety Interlock Pin
1
Chapter 2