Installing Accessories
SCSI Hard Drive
Removing a SCSI Hard Disk Drive
To remove the SCSI hard disk drive:
1. Turn off the display and shut down the Workstation. Disconnect all
power cables and any LAN or telecommunications cables.
2. Remove the Workstation's cover (see page 15).
3. Open the hard disk drive cage (see page 19).
4. Remove the hard disk drive from the cage by removing the four Torx
screws that hold the drive in place as shown in Figure 2-18.
Figure 2-18
Removing the Hard Disk Drive
38
This manual downloaded from http://www.manualowl.com
These 4 screws
(2 front, 2 back)
hold one hard
drive in place.
Screws for
installing a
second
hard disk
drive
Upper Bay
Lower Bay
Chapter 2