Removing A Hard Disk Drive From The Hard Drive Bay - HP Z800 Maintenance And Service Manual

Removing a hard disk drive from the hard drive bay

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3.
Press the hard drive carrier release latch at the green touch point and rotate the handle outward
(1). Pull the drive carrier out of the hard drive bay (2), as shown in the following figure.
Figure 5-39
ENWW
Removing the side access panel on page
Removing the drive carrier from the chassis
Predisassembly procedures on page
Removing and installing components
77).
79).
115