Removing A Hard Disk Drive From The Hard Drive Bay - HP Z800 Workstation Maintenance And Service Manual

Removing a hard disk drive from the hard drive bay

1.
2.
3.
4.
ENWW
Downloaded from www.Manualslib.com
Disconnect power from the workstation (see
Remove the side access panel (see
Press the hard drive carrier release latch at the green touch point and rotate the handle outward
. Pull the drive carrier out of the hard drive bay as shown in the following figure
Figure 5-39 Removing the drive carrier from the chassis
Carefully separate the upper hard drive carrier rails,
in the following figure.
Figure 5-40 Removing the drive from the carrier
Carefully separate the lower carrier rails
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
and then tilt the drive outward
, and then remove the drive from the carrier.
Removing and installing components 109
76).
78).
.
2
as shown
2