Installing The Hard Disk Drive Fan - HP x4000 Technical Reference Manual

Installing or Replacing Parts and Accessories
Hard Disk Drive Fan
Figure 10-30 Removing the Hard Disk Drive Fan

Installing the Hard Disk Drive Fan

To install the hard disk drive fan:
1. Attach the new hard disk drive fan to the chassis using the two
screws you removed previously.
2. Connect the hard disk drive fan power cable to the system board. For
the connector location, see "System Board Diagram" on page 198.
3. Close and secure the hard disk drive cage as described in "Closing
and Securing the Hard Disk Drive Cage" on page 150.
4. Return the Workstation to its upright position.
5. Replace the Workstation's cover as described in "Replacing the Cover
and Front Bezel" on page 148.
6. Reconnect all power and LAN cables.
196
This manual downloaded from http://www.manualowl.com
Remove
these two
screws.
Chapter 10