Installing An Ide Hard Disk Drive In The Top Rear Shelf - HP Vectra VL series 8 Maintenance Manual

CAUTION
1 How to Install Accessories In Your PC
Installing Mass Storage Devices
IDE drives are automatically detected by the Setup program. However,
a newly installed CD-ROM may require that you install an appropriate
device driver. Refer to your operating system documentation for
details. You can obtain the latest drivers from HP's Web site at:
http://www.hp.com/go/vectrasupport/

Installing an IDE Hard Disk Drive in the Top Rear Shelf

Handle the hard disk drive with care. Avoid shocks and violent
movement as this can cause damage to the hard disk drive's internal
components.
Make sure that you back up your files before you install a hard disk
drive. Refer to your operating system documentation for information on
how to do this.
The top rear shelf is located under the power supply. You can use this
shelf for a 3.5-inch hard disk drive. You can also use the top rear shelf
for installing a PCI accessory board.
The PC has an integrated Enhanced IDE controller which supports two
Ultra ATA IDE hard disk drives. Refer to the drive's documentation to
see if you must set jumpers or if there is a special installation
procedure to follow.
1 Disconnect the computer's power supply cord and any connection to
a telecommunication network.
2 Remove the computer's cover and power supply.
12 English
.