Installing A Hard Disk Drive In The Hard Drive Bay; Hard Disk Drive Cable Configuration - HP Z800 Maintenance And Service Manual

Installing a hard disk drive in the hard drive bay

This section describes how to install a hard drive in the hard drive bay.

Hard disk drive cable configuration

The hard drive bays are labeled 0 (top bay), 1, 2, and 3. (See
the Side access panel service label to locate the hard drive bays.)
The hard drive bays provide four data cables. They are labeled HDD BAY 0, HDD BAY 1, HDD
BAY 2, and HDD BAY 3.
The hard drive bay data cables are connected from the factory in the following manner:
SATA hard drive cables are plugged into SATA data port connectors on the system board, starting
●
at SATA data port connector zero.
SAS hard drive cables are plugged into SAS data port connectors on the system board, starting at
●
SAS data port connector zero.
If the last (highest drive bay number) hard drive plugged in is SAS, cables from empty hard drive
●
bays are plugged into SAS data port connectors on the system board.
If the last (highest drive bay number) hard drive plugged in is SATA, cables from empty hard drive
●
bays are plugged into SATA data port connectors on the system board.
You may need to reconfigure data cables if you install additional or replacement hard disk drives that
are different than the previously installed drives. (See
access panel service label to locate hard drive bays and data cable connectors.)
ENWW
Component locations on page 74
Component locations on page 74
Removing and installing components
or
or the Side
117