Configure Open Systems Management Server
Use these procedures to configure the open systems inband management program to
function with the switch.
NOTE: The optional Open Systems Management Server feature must be enabled in order to
perform this procedure.
To configure the Open Systems Management Server, use the following steps:
1. Select Management Server from the Configure menu on the menu bar.
The Configure Open Systems Management Server dialog box displays.
Figure 3–12: Configure Open Systems Management Server dialog box
2. Click the check box in the Host Control Prohibited field to display a check mark
and prohibit a host management program from changing configuration and
connectivity parameters on the switch. In this case, the host program has
read-only access to configuration and connectivity parameters. Clicking the check
box when it contains a check mark removes the check mark and allows a host
program to change configuration and connectivity parameters on the switch.
3. Activate changes and close the dialog box by clicking Activate.
4. If you are finished configuring the switch, you can back up the configuration data.
For more information, refer to
Configure FICON Management Server
Use this procedure to configure whether the host is the controlling manager.
NOTE: The optional FICON Management Server feature must be enabled in order to perform
Switch Clock Alert Mode
edge switch 2/16 product manager user guide
Backup and Restore Configuration on page
Configuring the Switch