Table of Contents
Advertisement
Set Switch Date and Time
Select this option to display the Configure Date and Time dialog box.
1. Click to display the Configure Date and Time dialog box.
The dialog box displays with a check mark (the default) in the Periodic Date/Time
Synchronization check box. If this field is checked, the HAFM server periodically
sets the switch time to automatically synchronize with the HAFM server time.
Daylight savings time automatically updates on the switch using this option.
The current date and time display in the Date and Time fields. If the Periodic
Date/Time Synchronization field is checked, the Date and Time fields are disabled
(grayed out).
To enable and disable Periodic Date/Time Synchronization, click the check box
and then click Activate.
Figure 2–5: Configure Date and Time Periodic Synchronization dialog box
2. Perform one of the following steps:
•
To immediately synchronize the switch date and time with the HAFM server, be
sure the Periodic Date/Time Synchronization option is enabled and then click Sync
Now.
NOTE: If you enable the Periodic Date/Time Synchronization feature and click Activate, the
time will synchronize at the next update period.
To set the switch with a specific date and time, make sure that the Periodic
Date/Time Synchronization field is not selected. Refer to
date and time and then click Activate.
S/390 mode only. An error will result if periodic synchronization and switch clock
alert mode are enabled (refer to
page
3-21)
edge switch 2/16 product manager user guide
Monitoring and Managing the Switch
Configure FICON Management Server on
Figure
2–6. Enter the
2–15
Advertisement
Table of Contents
