Procedure (Open Systems Mode) - HP StorageWorks 2/16 User Manual

Hp storageworks 2/16: user guide
Table of Contents

Advertisement

Configuring the Switch
Speed
Click the Speed column for a specific port, and select 2 Gb/sec, 1 Gb/sec, or
Negotiate. This sets the data rate for the port. Selecting "Negotiate" allows the
port to negotiate the data speed with an attached device. Follow this rule when
setting the data speed:
NOTE: Only set the speed to 2 Gb/sec on ports that support this speed. If the port optics do not
support 2 Gb/sec, a warning displays stating that the optical transceiver in the port does not
support the data rate.
When you change a port's speed and click Activate on the dialog box, a
confirmation message displays stating that this setting will temporarily disrupt
port data transfers.
Bound WWN
Enter a world wide name (WWN) in the proper format (xx.xx.xx.xx.xx.xx.xx.xx)
or a nickname configured through the HAFM application. The device with this
WWN or nickname will have exclusive attachment to the port if Port Binding is
enabled. If a valid WWN or nickname is not entered in this field, but the Port
Binding check box is checked (enabled), then no devices can connect to the port.
If you enter a WWN or nickname in this field and do not place a check in the Port
Binding checkbox, the WWN or nickname will be stored, and all devices can
connect to the port.

Procedure (Open Systems Mode)

To configure ports in open systems mode, use the following steps:
1. Select Ports from the Configure menu on the Product Manager menu bar.
The Configure Ports dialog box displays.
3–10
edge switch 2/16 product manager user guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks edge 2/16 product manager

Table of Contents