Configure Ports Dialog Box (S/390 Mode) - HP StorageWorks 2/16 User Manual

Hp storageworks 2/16: user guide
Table of Contents

Advertisement

Figure 3–7: Configure Ports dialog box (S/390 Mode)
Ports are numbered from 0 through 15.
2. Enable or disable extended distance buffering for the port by clicking the check
box in the 10-100 km column. When a check mark displays, extended distance
buffering is enabled.
3. Enable or disable LIN alerts for the port by clicking the check box in the LIN
Alerts column. When a check mark displays, LIN alerts are enabled.
NOTE: The factory default for LIN alerts is enabled.
4. To bind a device with a specific WWN or nickname to the port, click the WWN
Binding check box to display a check mark. Then enter the WWN or configured
nickname for the device into the Bound WWN column. The device that you bind to
the port will have exclusive connection to that port.
Notes:
If you have configured port binding and click Activate, a warning dialog box
displays if one or more of the nodes attached to a port does not match the
WWN or nickname configured in the Bound WWN column. This warning box
displays a list of all attached nodes that will be logged off if you continue. If
you click Continue, these nodes will log off and the port will only attach to the
device with the WWN or nickname configured in the Bound WWN column.
edge switch 2/16 product manager user guide
Configuring the Switch
3–13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks edge 2/16 product manager

Table of Contents