Procedure (S/390 Mode) - HP StorageWorks 2/16 User Manual

Hp storageworks 2/16: user guide
Table of Contents

Advertisement

Configuring the Switch
7. To bind a device with a specific WWN or nickname to the port, click the Port
Binding check box to display a check mark. Then enter the WWN or configured
nickname for the device into the Bound WWN column. The device that you bind to
the port will have exclusive connection to that port.
Notes:
If you have configured port binding and click Activate, a warning dialog box
displays if one or more of the nodes attached to a port does not match the
WWN or nickname configured in the Bound WWN column. This warning box
displays a list of all attached nodes that will be logged off if you continue. If
you click Continue, these nodes will log off and the port will only attach to the
device with the WWN or nickname configured in the Bound WWN column.
If you have configured port binding and click Activate, an error message may
display if the format for the WWN entered in the Bound WWN column is not
valid (not in xx.xx.xx.xx.xx.xx.xx.xx format) or if you enter a nickname that
has not been configured through the Product or HAFM.
8. To set the data speed for the port, click in the Speed column for the port, and select
1 Gb/sec, 2 Gb/sec, or Negotiate. Selecting Negotiate allows the port and attached
device to negotiate the data rate.
9. Use the scroll bar on the right side of the Configure Ports dialog box table to
display additional ports that you want to configure.
10. Activate changes and close the dialog box by clicking Activate.
11. If you are finished configuring the switch, back up the configuration data. For
more information, refer to
page
3-37.

Procedure (S/390 Mode)

To configure ports in S/390 mode, use the following steps:
1. Select Ports from the Configuration menu on the menu bar.
The Configure Ports dialog box displays.
3–12
Backing Up and Restoring Configuration Data on
edge switch 2/16 product manager user guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks edge 2/16 product manager

Table of Contents