Table of Contents
Advertisement
Product Manager Messages
Table A–1: HP StorageWorks Edge Switch 2/16 Product Manager Messages
Message
Are you sure you want to
send firmware version?
Cannot enable beaconing
on a failed FRU.
Cannot enable beaconing
while the system error light
is on.
Cannot have E_Ports
configured in S/390 mode.
Cannot have spaces in field.
Cannot install firmware to a
switch with a failed CTP
card.
Cannot perform this
operation while the switch is
offline.
Cannot retrieve current
SNMP configuration.
A–2
Description
Confirmation to add a
firmware version to the
firmware library. The
firmware library can hold
eight firmware versions.
Occurs when selecting
Enable Beaconing option for
a failed FRU.
Beaconing cannot be
enabled while the system
error light is on.
E_Ports are not allowed
when the operating mode of
the system is S/390.
Spaces are not allowed in
this field.
Firmware cannot be
installed on a switch with a
defective CTP card.
This operation cannot take
place while the switch is
offline.
The current SNMP
configuration cannot be
retrieved. The link is down
or busy.
edge switch 2/16 product manager user guide
Action
Click Yes to confirm adding
the firmware version to the
firmware library, or no to
cancel the operation.
Replace FRU and enable
beaconing again or enable
beaconing on operating
FRU.
Select Clear System Error
Light from Product menu to
clear error light, then enable
beaconing.
Informational Message.
Configure operating mode to
Open Systems mode
through the Configure
Operating Mode dialog box,
then configure ports as
E_Ports through the
Configure Ports dialog box.
Remove the spaces or
retype the field without
spaces.
Replace the switch and retry
the firmware install to the
switch.
Configure the switch offline
through the Set Online State
dialog box then retry the
operation.
Retry the operation later. If
the condition persists,
contact support personnel.
Advertisement
Table of Contents
