Table of Contents
Advertisement
Product Manager Messages
Table A–1: HP StorageWorks Edge Switch 2/16 Product Manager Messages
Message
Resource is unavailable.
Send firmware failed.
SNMP trap address not
defined.
Stop diagnostics failed. The
test is already running.
Stop diagnostics failed. The
test was not running.
Switch clock alert mode
must be cleared before
enabling period
synchronization.
System diagnostics cannot
run. The Operational Status
is invalid.
The add firmware process
has been aborted.
A–12
Description
The specified operation
cannot be performed
because the product is
unavailable.
Send firmware operation
has failed.
An SNMP trap address must
be defined if a community
name is defined.
Diagnostics for the port was
not running and the Stop
was selected on the Port
Diagnostics dialog box.
Diagnostics quit for the port
for some reason, but the
Stop button remains
enabled.
The action to stop
diagnostics failed because
the test was not running.
Clock alert mode is enabled
through the Configure
FICON Management Server
dialog box and user is
attempting to enable
Periodic Date/Time
Synchronization through the
Configure Date and Time
dialog box.
System diagnostics cannot
run on switches with failed
ports.
User has ended the add
firmware process.
edge switch 2/16 product manager user guide
Action
Verify that the HAFM
server-to-product link is up.
If the link is up, the HAFM
server may be busy. Try the
operation again later.
Retry the operation. If the
condition persists, contact
support personnel.
Define an SNMP address.
Verify port operation. Retry
diagnostics for port and
select Stop from the dialog
box. If problem persists,
contact your service
representative.
Informational message.
Disable clock alert mode
through the Configure
FICON Management Server
dialog box.
Replace failed ports.
N/A. An informational
message.
Advertisement
Table of Contents
