®
R&S
NGL200/NGM200
GPIB instrument address
To operate the instrument via remote control, it must be addressed using the GPIB
address. The default remote control address is factory-set at 20, the addresses of 0
through 30 are allowed.
The GPIB address is maintained after a reset of the instrument settings.
1. Select "GPIB Address" from the
The R&S NGL/NGM displays an on-screen keypad to set the value.
2. Enter the required value.
3. Confirm value with the enter key
6.16 General Instrument Settings
The following chapters provide the general instrument information and utilities services
in "Device" menu.
1. Press [Settings] key.
The R&S NGL/NGM displays the device/channel menu window.
2. Select the "Device" tab.
The R&S NGL/NGM displays the device menu.
6.16.1 Licenses Management
Options are enabled by entering a registered license key code.
You may choose to install from an XML file on USB or by manually entering the key
code.
► Select "Licenses" to install license key code.
User Manual 1178.8736.02 ─ 06
General Instrument Settings
Figure
6-33.
.
Instrument Functions
82