Wireless Lan Connection - R&S NGM202 User Manual

®
R&S NGL200/NGM200
4. Set the required DHCP mode.
If DHCP mode is set "OFF", the following "Ethernet Settings" are required.
5. Configure the "IP Address", "Subnet Mask" and "Gateway".
The R&S NGL/NGM displays the IP dialog for configuration.
Figure 6-36: IP dialog
6. Set the required IP addresses for "IP Address", "Subnet Mask" and "Gateway"
7. Select "Set" to confirm the value.
8. Select "Apply Configuration" to apply the changes.
6.15.1.2

Wireless LAN Connection

Risk of RF exposure
When WLAN is active, a minimum separation distance of 20 cm from front panel of the
instrument must be observed at all times.
When WLAN is active, no operation of antenna or transmitter should be co-located with
the instrument.
Wi-Fi transmitter performance
Frequency range: 2412 MHz to 2472 MHz
Power: 19.5 dBm typical
Instrument option
R&S NGL-K102 (P/N: 3652.6362.02) or R&S NGM-K102 (P/N: 3644.6367.02) option is
required to connect the R&S NGL/NGM to a network via wireless LAN connection.
User Manual 1178.8736.02 ─ 06
Instrument Functions
Interfaces
79