R&S NGM202 User Manual page 62

®
R&S NGL200/NGM200
Trigger-in parameters
CC, CV, CR, Protection, Sink Operation Mode
User button
*TRG
Table 6-4: Trigger-out signals
Trigger-out parameters
Output channel
Digital Output Fault
Digital Output Out1
Digital Output Out2
Logging
Arb
FastLog
User Manual 1178.8736.02 ─ 06
Source Descriptions
If respective channel
event
trigger-out parameters are triggered.
See
User button If detected, corresponding trigger-out parameters
are triggered.
SCPI command (*TRG)
remotely send to instru- See
ment
Trigger conditions Descriptions
Output On If a trigger is detected, respective channel output
of the instrument turns on or off.
Output Off
Gated
CC, CV, CR, Protection If respective channel
and Sink, Output Off event
sent out at pin 11 of the
See
Trigger-in signal If detected, a trigger signal is sent out at pin 4 of
the
Output On Ch 1
Trigger-in signal If detected, a trigger signal is sent out at pin 12 of
the
Output On Ch 2
Trigger-in signal If detected, the data logger starts recording the
instrument.
Start triggered If a trigger is detected, respective channel starts
generating a complete arbitrary signal or steps
Stop triggered
through the arbitrary signal for every trigger signal
detected.
The step time from the arbitrary signal is ignored
in the case when trigger condition is set as "Stop
triggered".
Trigger-in signal If detected, the FastLog module is enabled and
starts acquiring measurement data.
Instrument Functions
Trigger / Digital I/O
operation modes,
or sink mode is detected, corresponding
Figure 6-18.
Figure 6-18.
operation modes,
or sink mode is detected, a trigger signal is
Digital I/O
Figure 6-19.
Digital I/O connector.
Digital I/O connector.
protection
protection
connector.
59