R&S NGM202 User Manual page 61

®
R&S NGL200/NGM200
Figure 6-18: Overview of trigger IO system
Table 6-3: Trigger-in signals
Trigger-in parameters
Ext trigger Ch1
Ext trigger Ch2
Digital I/O IN1
Output channel 1
Output channel 2
Any of the channels
User Manual 1178.8736.02 ─ 06
Source Descriptions
Digital In, pin 2 of Digi- If detected, corresponding trigger-out parameters
tal I/O connector are triggered.
Digital In, pin 10 of Dig- The ext trigger signal is low active (inverted logic).
ital I/O connector
See
Digital In, pin 3 of Digi- If detected, corresponding trigger-out parameters
tal I/O connector are triggered.
The Digital I/O IN1 signal is low active (inverted
logic).
See
Output If respective channel output is turned on, corre-
sponding trigger-out parameters are triggered.
See
Instrument Functions
Trigger / Digital I/O
Figure 6-18.
Figure 6-18.
Figure 6-18.
58