R&S NGM202 User Manual page 97

®
R&S NGL200/NGM200
TRIGger[:STATe]
TRIGger[:SEQuence][:IMMediate]:SOURce
TRIGger[:SEQuence][:IMMediate]:SOURce:DIO:CHANnel
TRIGger[:SEQuence][:IMMediate]:SOURce:DIO:PIN
TRIGger[:SEQuence][:IMMediate]:SOURce:OMODe
TRIGger[:SEQuence][:IMMediate]:SOURce:OMODe:CHANnel
TRIGger[:SEQuence][:IMMediate]:SOURce:OUTPut:CHANnel
TRIGger[:STATe] <arg0>
Enables or disables the trigger system.
Upon being triggered, the selected trigger source
IMMediate]:SOURce
See
Setting parameters:
<arg0>
TRIGger[:SEQuence][:IMMediate]:SOURce <arg0>
TRIGger[:SEQuence][:IMMediate]:SOURce? <arg0>
Sets or queries the trigger source.
See
Parameters for setting and query:
<arg0>
Example:
TRIGger[:SEQuence][:IMMediate]:SOURce:DIO:CHANnel <arg0>
TRIGger[:SEQuence][:IMMediate]:SOURce:DIO:CHANnel? <arg0>
Sets or queries the device channel for trigger source "Digital In Channel".
User Manual 1178.8736.02 ─ 06
..............................................................................................................94
on page 94 becomes active.
Figure 6-18.
1 | 0
1
Enables the trigger system.
0
Disables the trigger system.
Figure 6-18.
OUTPut | OMODe | DIO
OUTPut
Trigger source is from the output channel (Ch1, Ch2).
OMODe
Trigger source is from the different modes (CC, CR, CV, Sink,
OVP, OCP, OPP and OTP) detected from the output channel
(Ch1, Ch2).
DIO
Trigger source is from DIO connector at the instrument rear
panel.
TRIG:SOUR OMOD
Trigger source "Operation Modes" is selected for monitoring.
Remote Control Commands
........................................................................ 94
................................................... 94
........................................................... 95
........................................................... 95
.............................................96
............................................. 96
TRIGger[:SEQuence][:
Trigger Commands
94