®
R&S
NGL200/NGM200
ARBitrary:TRANsfer
ARBitrary:TRIGgered:MODE
ARBitrary:TRIGgered[:STATe]
ARBitrary[:STATe] <state>
ARBitrary[:STATe]?
Sets or queries the arbitrary function for the previous selected channel.
Parameters:
<state>
Example:
ARBitrary:BEHavior:END <state>
ARBitrary:BEHavior:END?
Sets or queries the arbitrary endpoint behavior, when arbitrary function is finished.
Parameters:
<state>
Example:
ARBitrary:CLEar
Clears the previous defined arbitrary waveform data for the selected channel.
Example:
Usage:
User Manual 1178.8736.02 ─ 06
....................................................................................................... 134
...........................................................................................135
..........................................................................................135
OFF | ON | 1 | 0
ON | 1
Arbitrary function is activated.
OFF | 0
Arbitrary function is deactivated.
*RST:
OFF | 0
ARB ON
ARB? -> 1
Arbitrary function of Ch1 is activated.
See
Example "Configuring an arbitrary sequence"
HOLD | OFF
OFF
If the arbitrary function is finished, the respective channel is
deactivated automatically.
HOLD
If the arbitrary function is finished, the last arbitrary point of the
user-defined arbitrary list is held.
*RST:
OFF
See
Example "Configuring an arbitrary sequence"
See
Example "Configuring an arbitrary sequence"
Event
Remote Control Commands
Advanced Operating Commands
on page 131.
on page 131.
on page 131.
132