R&S NGM202 User Manual page 116

®
R&S NGL200/NGM200
OUTPut:DELay[:STATe] <state>
OUTPut:DELay[:STATe]?
Sets or queries the output delay state for the selected channel.
Parameters:
<state>
Example:
OUTPut:FTResponse <state>
OUTPut:FTResponse?
Sets or queries the fast transient response state.
Parameters:
<state>
Example:
OUTPut:IMPedance <resistance>
OUTPut:IMPedance?
Sets or queries source impedance for the signal specified in ohms.
Parameters:
<arg0>
User Manual 1178.8736.02 ─ 06
OFF | ON | 0 | 1
OFF | 0
Deactivates output delay for the selected channel.
ON | 1
Activates output delay for the selected channel.
OUTPut:DELay 1
OUTPut:DELay? -> 1
Returns output delay state as on.
OFF | ON | 0 | 1
OFF | 0
Deactivates fast transient response.
ON | 1
Activates fast transient response.
OUTPut:FTResponse 1
OUTPut:FTResponse? -> 1
Returns fast transient response state as on.
numeric | MIN | MAX | DEFault
numeric
Numeric value of the impedance ohm.
MIN
Minimum value of the impedance at -0.05 ohms.
MAX
Maximum value of the impedance at 100 ohms.
DEF
Default value of the impedance at 0 ohms.
*RST: 0
Default unit: ohm
Remote Control Commands
Configuration Commands
113