Connecting To A Network; Lan Connection; Wired Connection - R&S NGE-K101 User Manual

www.allice.de
®
R&S NGE100B

5.6 Connecting to a Network

5.6.1 LAN Connection

5.6.1.1
User Manual 5601.1343.02 ─ 02
3. Select "Trigger In" to accept external trigger signal or "Trigger Out" to output the
trigger signal.
4. Set the desired channel.
5. Select the desired trigger condition.
See Table 5-11 and Table
6. Set the desired "Logic" state.
7. Set the status to "Enabled".
The R&S NGE100B enabled the selected DIO interface and monitor or feedback
the trigger condition onto the selected channel.
R&S NGE-K101 (order number: 5601.2204.03) option is required to connect the R&S
NGE100B to a network via LAN connection.
There are two methods to establish a local area network (LAN) connection with the
R&S NGE100B for remote control operation.

Wired Connection

The network card can be operated with a 10 Mbps Ethernet IEEE 802.3 or a 100 Mbps
Ethernet IEEE 802.3u interface.
Risk of network failure
Before connecting the instrument to the network or configuring the network, consult
your network administrator. Errors may affect the entire network.
To establish a network connection, connect a commercial RJ-45 cable to the LAN port
of the instrument and to a PC.
Allice Messtechnik GmbH
5-12.
Instrument Functions
Connecting to a Network
48