Wireless Lan Connection - R&S NGE100B User Manual

®
R&S NGE100B
Table 6-5: Ethernet input field
Ethernet input field
"MAC Address"
"Status"
"IP Mode"
"IP Address"
"Subnet Mask"
"Default Gateway"
"Reset LAN"
"Apply"
6.9.1.2

Wireless LAN connection

Risk of RF exposure
When WLAN is active, a minimum separation distance of 20 cm from front panel of the
instrument must be observed at all times.
When WLAN is active, no operation of antenna or transmitter should be co-located with
the instrument.
Wi-Fi transmitter performance
Frequency range: 2412 MHz to 2484 MHz
Power: 19.5 dBm typical
Instrument option
R&S NGE-K102 (order number: 5601.2210.03) option is required to connect the R&S
NGE100B to a network via WLAN connection.
Wireless LAN option is only available for instrument with serial number below 110000.
User Manual 5601.1343.02 ─ 09
Instrument functions
Interfaces and protocols
Description
Shows the MAC address of this instrument.
Shows if the connection is up or down.
"Static & Manual": Manually configure an IP address
for the instrument.
"DHCP & Auto-IP": Automatically assign an IP
address to the instrument.
Address used in communication with the network.
Manually configure this field if IP mode set to "Static
& Manual".
Secondary address used in communication with the
network.
Manually configure this field if IP mode set to "Static
& Manual".
Gateway address to connect to the network.
Manually configure this field if IP mode set to "Static
& Manual".
Restores the LAN settings to factory default.
It also removes the LXI web password.
Apply static IP settings.
56