Table of Contents
Advertisement
www.allice.de
®
R&S
NGE100B
6.5.6 Output Setting
User Manual 5601.1343.02 ─ 02
Parameters:
<arg0>
{1 | 2 | 3}
Example:
INSTrument:NSELect 1
Selects the output channel as Ch 1.
Note: Channel 3 is only valid for NGE103B.
INSTrument:NSELect? -> 1
Return the numeric channel selection.
INSTrument[:SELect] <arg0>
This command defines or queries the channel selection. Each channel of the power
supply is considered as separate "instrument", which is required by the SCPI standard.
Parameters:
<arg0>
OUTPut1 | OUTPut2 | OUTPut3 | OUTP1 | OUTP2 | OUTP3 |
OUT1 | OUT2 | OUT3
OUTPut1 | OUTP1
Ch 1
OUTPut2 | OUTP2
Ch 2
OUTPut3 |OUTP3
Ch 3
Example:
INSTrument OUTPut1
INSTrument OUTP1
Selects the output channel as Ch 1.
INST? -> 2
Return the output channel as Ch 2.
OUTPut[:STATe] <arg0>
This command defines or queries for output state for the previous selected channel.
Parameters:
<arg0>
{OFF | ON | 0 | 1}
ON | 1
Output state will be turned on.
OFF | 0
Output state will be turned off.
*RST:
Allice Messtechnik GmbH
Remote Control - Commands
OFF | 0
Remote Control
80
Advertisement
Table of Contents
