Trying Out The Instrument; Selecting The Channels; Setting The Output Voltage And Current Limit - R&S NGE102B Getting Started

®
R&S NGE100B
7

Trying out the instrument

This chapter describes some basic functions that you can perform with the R&S
NGE100B.
7.1

Selecting the channels

To select a channel, press the corresponding channel key. The key illuminates.
7.2

Setting the output voltage and current limit

To set the output voltage and current limit via Live-Mode:
1. Long press the rotary knob to enter into editing mode.
By default, the voltage at channel 1 is selected.
2. Use arrow keys to select the desired parameter (voltage or current).
3. Rotate the rotary knob to adjust value.
4. To exit Live-Mode, press the rotary knob.
Alternatively:
1. Press [Voltage] or [Current] key on the front panel.
2. Press the desired channel key to activate the respective voltage or current
limit setting of that channel. The value on the respective channel becomes
editable and is positioned by a blue cursor.
3. Press the [Left] or [Right] arrow key to move the cursor.
4. Press the [Up]/[Down] arrow key or turn the rotary knob to change the value.
The new value registers immediately.
Getting Started 5601.1337.02 ─ 08
Trying out the instrument
Setting the output voltage and current limit
24